Bathroom fitters in High Wycombe, Buckinghamshire

Bath fitters in High Wycombe: a new bath, toilet or basin fitted without a full refit

Single jobs include a new bath, toilet, basin, towel rail, extractor fan or fresh sealant. Fill in the short form, pick a call back time that suits you, and a local bathroom fitter rings then with a free quote.

Get a free bathroom quote

A minute of your time. No email address needed.

By sending this form you agree to your details being shared with a local bathroom fitter so they can contact you. See our privacy notice.

  • Baths and bath panels swapped, often in half a day
  • Toilets, basins, vanity units and taps replaced
  • Heated towel rails and extractor fans fitted
  • Old sealant cut out and the bath resealed properly

When only one part of the bathroom needs replacing

Not every bathroom needs gutting. Yours might be sound, with good tiles and a decent floor, and one thing that lets it down.

Perhaps the bath is scratched and stained past cleaning. Perhaps the toilet hisses all night, or the basin tap drips a green streak down the bowl. Perhaps the towels never dry because the radiator is hidden behind the door.

Small faults like these are easy to live with and wearing all the same. Most take a fitter a few hours to cure.

From short form to a price for your bathroom

  1. Describe the bathroom

    Give your name, a number you answer and your part of High Wycombe. Then say what is wrong with the room, or what you would like it to become. The rough size helps, and so does saying if the bath, basin and toilet are staying where they are.

  2. A local bathroom fitter rings you

    Your phone rings at the hour you asked for. Expect a few questions about the room, then an offer to come round and measure, because nobody can price a bathroom properly from a description alone.

  3. Weigh it up, then choose

    You receive a price for your own bathroom. Have it written down, set it beside any others you have collected, and say yes only when it suits you. The asking costs you nothing.

Smaller bathroom jobs a fitter will take on

A new bath

The old bath is disconnected and carried out, the new one is set level on its frame, connected, tested and sealed. The bath installation cost guide says a plain swap takes two to four hours, with labour of £280 to £390 including taking the old bath away.

Bath panels

A cracked or swollen panel spoils a clean bathroom. A new front panel is listed in the same guide at £45 to £125 to buy. A good fitter makes it removable, so the pipes behind can be reached without breaking anything.

Toilets

A toilet that runs on, rocks on the floor or leaks at the back can often be repaired. If the pan is cracked or the style is long out of date, a like-for-like swap is quick.

Basins and vanity units

A pedestal basin can give way to a unit with drawers beneath, which hides the pipes and gives you somewhere to put the bottles that crowd the windowsill.

Towel radiators

A rail can run from the central heating, from the electrics or from both. The dual kind dries towels in summer when the boiler is off.

Extractor fans

A fan that is quiet, strong enough for the room and set to run on after the light goes off. It does more to stop mould than any paint.

Resealing

Every scrap of the old sealant is cut out, the gap is cleaned and dried, and a new bead goes in with the bath full of water so the joint sets at its widest.

Typical prices for single bathroom jobs

Select one of these jobs. Up comes the price band a UK guide gives for it.

Get a price for your own bathroom

A minute of your time. No email address needed.

By sending this form you agree to your details being shared with a local bathroom fitter so they can contact you. See our privacy notice.

All the guide prices side by side

JobUK guide price
Toilet and basin, supplied and fittedA toilet and a basin, with labour of £300 to £400 and the rest on the fittings themselves.£430 to £1,200
Replacing a bathTaking out the old bath and supplying and fitting a standard acrylic bath that sits against two walls. The guide's average for having a bath installed is £700.£500 to £800typical about £700
New bathroom extractor fanFitting an extractor fan in a bathroom that had none, with the fan unit included.£250 to £350typical about £300
Heated towel rail, fitted: ElectricInstalling an electric heated towel rail.£150 to £600
Heated towel rail, fitted: Central heatingInstalling a heated towel rail that runs off the central heating.£200 to £800
Heated towel rail, fitted: Dual fuelInstalling a dual fuel rail, which works from the heating and from an electric element. The guide says the top figure can be exceeded.£300 to £1,000

The figures here are typical UK guide prices, each copied from a published UK cost guide. None is a quote. The real price of your bathroom depends on its size, the suite and tiles you pick, the state of the pipes, floor and walls, and anything that only shows once the old room is stripped out.

Choosing a bath that will last

Most baths sold in Britain are acrylic or steel. Acrylic is warm to the touch, light to carry up a narrow staircase and the cheaper of the two. It needs a rigid frame and solid support, or it flexes and breaks its seal.

Steel is heavier and colder at first, but it is very stiff and its enamel shrugs off scratches. The cost guide puts a standard acrylic bath, fitted, at £500 to £800 and a standard steel one at £620 to £1,200.

Size matters more than material in many High Wycombe bathrooms. The standard length is 1,700mm. Rooms squeezed into the back of a terrace sometimes only take 1,500mm or 1,600mm, so measure between the finished walls before you fall for a bath in a showroom.

Because the water here is hard, look at the taps as well. A tap with ceramic discs that can be replaced will outlast one that has to be thrown away when scale gets into it.

When a small job turns out to be a bigger one

Now and then a simple swap uncovers something. The fitter lifts the old bath and finds the floor beneath is black and soft. Or the toilet comes off and the pipe behind is cracked.

A decent fitter stops, shows you and gives you a price for putting it right before carrying on. That is a nuisance on the day, yet it is far better than a new bath sitting on a rotten floor.

If you already suspect the trouble goes deeper, with stains below, a musty smell or tiles coming loose, say so in the form. It may be that a full bathroom installation is the better use of your money, and it is best to hear that before you buy a bath.

Combine small jobs into one visit

A fitter's time is cheapest when it is not spent driving. If you have three small jobs, ask for them together. A new bath, a towel rail and a fan done in one day will cost less than three separate call-outs.

Have the parts in the house if you are supplying them, and clear the bathroom of bottles, mats and laundry. In the steep, narrow roads on the valley sides, say where a van can stop. These small things keep a half-day job to half a day.

Bathroom services in High Wycombe

Areas served in and around High Wycombe

Bathroom fitting across the town, up both sides of the valley and out to these places.

  • Town centre, Desborough and Castlefield
  • Wycombe Marsh and Micklefield
  • Totteridge, Bowerdean and Terriers
  • Downley and Sands
  • Booker and Cressex
  • Daws Hill and Marlow Hill
  • Amersham Hill
  • Hazlemere and Tylers Green
  • Loudwater and Flackwell Heath
  • Hughenden Valley, Naphill and Walters Ash
  • Holmer Green and Great Kingshill
  • West Wycombe
  • Marlow
  • Beaconsfield

See the full list of areas around High Wycombe

Things to know before you fill in the form

  • There is no fee. Sending the form is free, and the price that follows comes with no duty to accept it. Say no whenever you like.
  • The form is short. It wants to know who you are, how to ring you, roughly where you live and what the bathroom needs. It does not want an email address or a door number.
  • Prices here come from published guides. The costs quoted on these pages were taken from published UK cost guides that anyone can read. Use the figures to set a budget. The price for your own bathroom is the one that matters.
  • Your details are for this bathroom only. They are used to get your enquiry answered and for no other purpose. They are never traded.

Common questions

Can a new bath go in without damaging the tiles?

Often, if the new bath is the same length and height as the old one. The bottom row of tiles usually sits on the bath edge, so there is a risk of losing a few. Keep any spare tiles you have, and tell the fitter if there are none, as it changes how they go about it.

Why does my toilet keep running after it has flushed?

In most modern toilets the cause is a worn seal on the flush valve or a filling valve that no longer shuts off. Both are inexpensive parts. Limescale makes them fail sooner in a hard water area. A fitter can usually change them without replacing the toilet.

How often should a bath be resealed?

There is no fixed interval. Reseal when you see the bead lifting, splitting or going black beneath the surface, where cleaning cannot reach. Sealant applied with the bath full, on a bath that is properly supported, lasts far longer than a quick bead over the top of the old one.

Fix small bathroom faults before they get worse

A dripping tap wastes water round the clock. A running toilet does the same and can add to a metered bill. A failed seal lets a cupful of water behind the bath with each shower. None of it is dramatic, and all of it is cheaper to stop now than to repair later.

List what needs replacing and say where in High Wycombe you are. No fee, no strings.

Get a free bathroom quote

A minute of your time. No email address needed.

By sending this form you agree to your details being shared with a local bathroom fitter so they can contact you. See our privacy notice.

Get a free quote